![]() |
#1 |
Connoisseur
![]() ![]() Posts: 95
Karma: 144
Join Date: May 2018
Device: Boyue Likebook Muses T78D
|
Android 8.1 available for Mars.
Boyue announcedhttps://m.facebook.com/story.php?sto...84952745068650 it on its Facebook page
|
![]() |
![]() |
![]() |
#2 |
Junior Member
![]() Posts: 3
Karma: 10
Join Date: Jan 2020
Device: Likebook Mars
|
I followed the directions and so far my Mars is stuck with a black screen after the update supposedly finished. It's still connected to my computer for about half an hour and I'm waiting to see if it suddenly springs to life.
|
![]() |
![]() |
Advert | |
|
![]() |
#3 |
Member
![]() Posts: 19
Karma: 10
Join Date: Jul 2017
Device: Kindle Paperwhite Gen 11 & Likebook Mars
|
|
![]() |
![]() |
![]() |
#4 |
Junior Member
![]() Posts: 3
Karma: 10
Join Date: Jan 2020
Device: Likebook Mars
|
Nope... I tried again and I think there's something wrong with the image file they uploaded because at the end of the install when your Mars reboots, it displays a message that says "erasing". I've used this same method to update other Android devices without any problems.
|
![]() |
![]() |
![]() |
#5 | |
Connoisseur
![]() ![]() Posts: 95
Karma: 144
Join Date: May 2018
Device: Boyue Likebook Muses T78D
|
Quote:
|
|
![]() |
![]() |
Advert | |
|
![]() |
#6 | |
Incanus
![]() ![]() ![]() Posts: 275
Karma: 210
Join Date: Oct 2017
Location: Chile
Device: Boyue Likebook T80D
|
![]() Quote:
It's too early to coment on the device battery behaviour and such, but so far:
I'll post here if and when I get more stats or details on how this upgrade works on the Likebook Mars Reader. Kind regards, [INCANUS] Last edited by Incanus; 08-24-2020 at 11:52 AM. Reason: Title missing |
|
![]() |
![]() |
![]() |
#7 |
Junior Member
![]() Posts: 4
Karma: 10
Join Date: Aug 2020
Device: Likebook Mars
|
Updated to 8.1 last night and didn’t have any issues getting it to update. Going to have to use it for a week or so to give a fair appraisal, but first impressions were not great.
Initial thoughts/concerns: -Battery: Made sure it was fully charged before doing update and after update (which took about half an hour) and an hour of reading, battery was drained to below 80%. Yes light was on for reading, but on prior firmware it would take a week of night reading (6 to 8 hours over the course of a week) to see the battery drain that much. The majority of the drain might have been during the updating process, so will have to see how it does over time. -Stock reader: Cuts far more words in half than previous version. Previous version would so this some, but it’s much, much more noticeable now. What I mean is this paragraph on the stock reader could look like this depending on how big you size the font: Cuts far more words in half than previous ver- sion. Previous version would so this some, but it’s much, much more noticeable now. What I m- ean is this paragraph on the stock reader could lo- ok like this depending on how big you size the font It’s annoying to the point that I’m going to have to give another reading app a try. Will try KoReader tonight. If battery drain continues, I might give reverting back to older firmware a try. Nothing immediately stood out to me as an improvement and so the real reason for updating to 8.1 would be for the added security of a newer OS, but for me I leave wifi off 98% of the time and never make any purchases directly via the eReader. |
![]() |
![]() |
![]() |
#8 | |
Junior Member
![]() Posts: 3
Karma: 10
Join Date: Jan 2020
Device: Likebook Mars
|
Quote:
Then explain why everything works fine and then it says "erasing" at the end of the install? Brave enough to try it yourself? |
|
![]() |
![]() |
![]() |
#9 |
Junior Member
![]() Posts: 4
Karma: 10
Join Date: Aug 2020
Device: Likebook Mars
|
Tried it myself on mine and it worked for me.
Process was a bit different than most other devices I have experience side loading firmware on to, but went slow and followed the directions. Somethings I found non-standard: -Likebook Mars needed to be OFF. -Had to press a paperclip into the device reset hole and keep it pressed until after the firmware image was given the go to start loading. -Could only connect USB cable after paperclip was pressing the reset button Other suggestions to try if you haven't already - not in front of my home PC right now to look at the container that the firmware image was in when downloaded (zip or rar), but if rar, unrar using 7Zip if you used other software to unrar. - try a different USB cable - try loading an older firmware image |
![]() |
![]() |
![]() |
#10 |
Member
![]() Posts: 10
Karma: 10
Join Date: Nov 2019
Device: likebook Mars T80D
|
Upgrade to 8.1 failed and device seems to be bricked
Today I did try the update and it started out as described.
It downloaded the image and showed "Download firmware success". It then did a verify step which was not shown in the upgrade instructions and then it showed the "Reset Device Start". But then the screen remained black. After about 15 minutes I did a reset and tried to restore my backup but it seems that the device ID is gone. The tool sees the likebook as adb device but I cannot switch to loader mode. Whe I try to read the flash ID or Info I always get a "match device type failed" error. I then tried to re-install the update.zip via SD card from a link tagged as "Likebook Mars T80D BYRead-V2.2.0-2020011014" which I found here in the forum, but it also failed. The error message is: This package is for "T80D" devices; this is a "" Is there a way to get the ID back into place and bring my reader back to life? |
![]() |
![]() |
![]() |
#11 |
Connoisseur
![]() ![]() Posts: 95
Karma: 144
Join Date: May 2018
Device: Boyue Likebook Muses T78D
|
|
![]() |
![]() |
![]() |
#12 |
Junior Member
![]() Posts: 5
Karma: 10
Join Date: Aug 2020
Device: Boyue Likebook Mars T80D
|
I bought my Mars in February and I'm very happy with it so far.
Until I upgraded my device to 8.1 today. I used the instructions, I flashed ver. 2020081915, which should be from last Wednesday as far as I can see. The only problem which I'm experiencing is that my device became very unstable, it boots for several minutes, it randomly displays that System UI is not responding, and something doesn't look right at all. Besides, something is eating the battery very fast. Any advice how to proceed? Probably I must flash the device once again, but I don't see how the result can be different if I do one and same thing. Anyone experiencing the same problem? |
![]() |
![]() |
![]() |
#13 |
Junior Member
![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() Posts: 7
Karma: 1152
Join Date: Aug 2020
Device: Likebook Mars
|
Hi! I ordered a Likebook Mars and I'm expecting it in a few days, in the meantime. I've explored different options for rooting it and this is what I've done:
1) Download the new Android 8.1 update package 2) Unpack the update-10225.img file with imgRePackerRK 3) Copy the boot image to your Android phone 4) Download and install the latest Magisk Manager in your Android phone 5) Press Install → Install → Select and Patch a File, and select your stock boot image file 6) Magisk Manager will patch the image, and store it in [Internal Storage]/Download/magisk_patched.img 7) Copy the patched image from your device to your PC. If you can’t find it via MTP, you can pull the file with ADB: adb pull /sdcard/Download/magisk_patched.img 8) Rename it to boot.img. Find the folder where you originally copied it from (update-10225.img.dump) and replace it with the unpatched boot.img 9) Repack the update-10225.img with imgRePackerRK and follow the update procedure as explained by Likebook Instructions on how to use imgRePackerRK and dowload https://forum.xda-developers.com/sho....php?t=2257331 It's a simple process and should work reliably. If you get stuck in a bootloop you can redo the update process with original unpatched update-10225.img to get back up and running. Once you have root access you can flash NanoDroid-microG-22.6.91.20200821 through the magisk app and you'll get rid of the battery sucking spying google apps while mantaining a fully functional system. Another interesting option once rooted is to monitor any suspicious app sending data in the background. Now you can debloat/disable unwanted apps and have full control of your system. |
![]() |
![]() |
![]() |
#14 |
Addict
![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() Posts: 200
Karma: 9146378
Join Date: Sep 2018
Location: New York State, USA
Device: Kindle Touch, DX, PW4, PW5, Scribe; Likebook Mars; Fire HD 8; iPad
|
I have read the instructions and downloaded the other files. The files are:
The instructions mention rooting. Since the instructions were probably written by a Chinese person or translated from Chinese, I wanted to ask if anyone has checked that the device is actually rooted after the update. |
![]() |
![]() |
![]() |
#15 |
Addict
![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() Posts: 200
Karma: 9146378
Join Date: Sep 2018
Location: New York State, USA
Device: Kindle Touch, DX, PW4, PW5, Scribe; Likebook Mars; Fire HD 8; iPad
|
Since I recently had to change the SD card on my Likebook Mars, which involved reinstalling everything, I wanted to mention one thing I learned. If you're using Moon+ Reader, or probably any other ereader app that is not tied to a cloud, keep track of where you left off in the books you're reading. Although I was able to get back the books I was reading with Moon+ Reader, I lost my place in them. Don't let that happen to you when you update.
|
![]() |
![]() |
![]() |
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Likebook Mars stocking in Android Recovery Mode | Flyout | Boyue | 26 | 09-30-2020 10:21 AM |
How To Get KOReader Working on Android 6 Boyue Likebook Mars | Incanus | KOReader | 2 | 09-03-2020 04:36 PM |
Likebook Mars | gezgez | Boyue | 11 | 09-22-2019 12:53 AM |
Apps for Boyue Likebook Mars T80D (Android 6) | nick2011 | Boyue | 0 | 12-31-2018 12:04 PM |
Would You Go To Mars? | kennyc | Lounge | 31 | 12-13-2012 07:54 AM |