*VERY* detailed guide on changing default Reader fonts - Page 2

Valloric · 09-03-2008, 09:20 PM

Quote:

Originally Posted by Rontonio

After doing some reading at lunch I see that words, and even entire lines are missing after some page turns. I originally flashed an empty reader and reloaded the books after installing the new font, but maybe I needed to reload the original book files rather than those from the Reader with the Dutch font?

Yes, that is the correct procedure. After reading that section of the guide, it does seem a bit ambiguous. Will update that tomorrow.

And yes, if you use Sony's eBook Library to transfer ebooks to the Reader, you need to replace its fonts as well since it will paginate books when you transfer them in the fonts the library itself uses. I'll note that in the new version of the guide too.

I use calibre so it slipped my mind to mention that.

Rontonio · 09-03-2008, 10:49 PM

By identical fonts do you mean the Caecilia that I renamed Dutch with the Font Creator program to trick the reader when I installed the hack? Also, how do I get the new font into the reader library? Delete the cache .xml on the reader?

igorsk · 09-04-2008, 08:14 AM

The files in "\Program Files\Sony\Reader\Data\fonts" should be exactly the same as the ones you upload to the Reader.

Valloric · 09-04-2008, 09:31 AM

Quote:

Originally Posted by Rontonio

By identical fonts do you mean the Caecilia that I renamed Dutch with the Font Creator program to trick the reader when I installed the hack? Also, how do I get the new font into the reader library? Delete the cache .xml on the reader?

Quote:

Originally Posted by igorsk

The files in "\Program Files\Sony\Reader\Data\fonts" should be exactly the same as the ones you upload to the Reader.

This is already in the guide: Appendix E, page 17.

Rontonio · 09-04-2008, 12:55 PM

OK. It's all much clearer now. Last night I dragged the book files from my HD directly into the Reader and the device formatted the books correctly. I have replaced the font file in the eBook library with the one I created for the Reader as you suggested. It should all be good now. I really like the new font, and appreciate the clock. Thanks again.

mulderfox · 09-07-2008, 08:44 AM

Can I add hebrew font support this way?

Valloric · 09-07-2008, 09:25 AM

Quote:

Originally Posted by mulderfox

Can I add hebrew font support this way?

I think you should be able to. If your font has hebrew support, it should work. Use Sony's eBook Library software to preview your book and check if your font works (instructions on how change the eBook Library's fonts are in Appendix E of the guide).

JSWolf · 09-07-2008, 09:29 AM

Times New Roman has Hebrew support in the upper characters.

mulderfox · 09-08-2008, 09:22 AM

thanks!

Ha3hem · 09-12-2008, 11:05 AM

Thanks for the guide.
I have a big question: how can i read persian(Farsi) ebooks in my 505 ?
Can I replace default fonts with Farsi fonts ?

regards.

Valloric · 09-12-2008, 12:46 PM

Quote:

Originally Posted by Ha3hem

Thanks for the guide.
I have a big question: how can i read persian(Farsi) ebooks in my 505 ?
Can I replace default fonts with Farsi fonts ?

regards.

Well, is Farsi written (and read) right-to-left? If it is, I'm afraid you're out of luck. As far as I know, the Reader doesn't display right-to-left fonts correctly...

If Farsi is written left-to-right (like English), then all you need to do is replace the default font with a font that has Farsi characters (you of course need to have a Farsi e-book, too). The Reader supports Unicode.

rasbadar · 09-12-2008, 01:51 PM

Hi Valloric,

thank you for your detailed guide.
Now i will dare to change my default font (tonite), because i find the reader's default font quite un-legible.

I just wanted to buy the Ceacilia, but I found that there are many different versions (Std, Light, Roman etc.) . Which one are you using on the 505?

Thanks in advance

ras

Ha3hem · 09-12-2008, 05:45 PM

Thank you Valloric for answer.

Valloric · 09-12-2008, 09:37 PM

Quote:

Originally Posted by rasbadar

I just wanted to buy the Ceacilia, but I found that there are many different versions (Std, Light, Roman etc.) . Which one are you using on the 505?

I am using Caecilia LT Std Roman. When looking at font families, the "Roman" version is usually the default. Avoid "Heavy", "Light", "Italic" etc for general use.

mikeywilliams25 · 09-13-2008, 06:07 PM

Any idea what is going on here?
I reflashed the ereader using the PRS-505 Updater 1.1.00.18040.
Then I used the customiser to install and use the Cambria font (which had been modded as per instructions) and to change a couple of other settings (uniform font size and customisation).
All went well and the reader was fine - books were readable etc.
But when connected by USB (to a windowsxp machine) the reader was detected, calibre found it but the ebook library would not run (said error).
Upon disconnecting the usb the reader hung and needed to be reset.
Tried the above a couple of times but always the same - everything appeared to be fine until the usb was connected.
Tried different fonts - same problem.

Next I reflashed and again used the customiser but this time without changing the fonts.
Now everything worked as it should.
For some obscure reason changing the font is causing a problem ( i believe there was another poster a while back with a similar problem).
I am using a UK Reader - could that have anything to do with it?

Any suggestions as to what i might try?

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Kindle 2, Changing Default Dictionary	Alejandro	Amazon Kindle	9	06-22-2017 04:42 AM
Is it possible to flash or changing fonts of reader without card?	frodox	Sony Reader Dev Corner	5	04-21-2010 09:24 AM
Changing fonts on ECO reader??	troykm	HanLin eBook	2	12-23-2009 04:05 PM
Changing default font in Mobipocket?	smp_iliad	iRex	1	02-12-2009 10:46 PM
iLiad Changing the default sound	ericshliao	iRex Developer's Corner	4	12-21-2008 01:05 PM

09-03-2008, 10:49 PM	#17
Rontonio Member Posts: 17 Karma: 10 Join Date: Jul 2008 Device: Sony Reader	By identical fonts do you mean the Caecilia that I renamed Dutch with the Font Creator program to trick the reader when I installed the hack? Also, how do I get the new font into the reader library? Delete the cache .xml on the reader?

09-04-2008, 08:14 AM	#18
igorsk Wizard Posts: 3,442 Karma: 300001 Join Date: Sep 2006 Location: Belgium Device: PRS-500/505/700, Kindle, Cybook Gen3, Words Gear	The files in "\Program Files\Sony\Reader\Data\fonts" should be exactly the same as the ones you upload to the Reader.

09-04-2008, 12:55 PM	#20
Rontonio Member Posts: 17 Karma: 10 Join Date: Jul 2008 Device: Sony Reader	OK. It's all much clearer now. Last night I dragged the book files from my HD directly into the Reader and the device formatted the books correctly. I have replaced the font file in the eBook library with the one I created for the Reader as you suggested. It should all be good now. I really like the new font, and appreciate the clock. Thanks again.

09-07-2008, 08:44 AM	#21
mulderfox Junior Member Posts: 6 Karma: 10 Join Date: Sep 2008 Device: Sony PRS505	Can I add hebrew font support this way?

09-07-2008, 09:29 AM	#23
JSWolf Resident Curmudgeon Posts: 76,505 Karma: 136564766 Join Date: Nov 2006 Location: Roslindale, Massachusetts Device: Kobo Libra 2, Kobo Aura H2O, PRS-650, PRS-T1, nook STR, PW3	Times New Roman has Hebrew support in the upper characters.

09-08-2008, 09:22 AM	#24
mulderfox Junior Member Posts: 6 Karma: 10 Join Date: Sep 2008 Device: Sony PRS505	thanks!

09-12-2008, 11:05 AM	#25
Ha3hem Junior Member Posts: 3 Karma: 10 Join Date: Sep 2008 Location: Iran Device: Sony eReader Prs-505	Thanks for the guide. I have a big question: how can i read persian(Farsi) ebooks in my 505 ? Can I replace default fonts with Farsi fonts ? regards.

09-12-2008, 01:51 PM	#27
rasbadar Enthusiast Posts: 35 Karma: 10 Join Date: Sep 2008 Device: PRS-650, PRS-505	Hi Valloric, thank you for your detailed guide. Now i will dare to change my default font (tonite), because i find the reader's default font quite un-legible. I just wanted to buy the Ceacilia, but I found that there are many different versions (Std, Light, Roman etc.) . Which one are you using on the 505? Thanks in advance ras

09-12-2008, 05:45 PM	#28
Ha3hem Junior Member Posts: 3 Karma: 10 Join Date: Sep 2008 Location: Iran Device: Sony eReader Prs-505	Thank you Valloric for answer.

09-13-2008, 06:07 PM	#30
mikeywilliams25 Enthusiast Posts: 48 Karma: 10 Join Date: Aug 2008 Location: London Device: Kobo GloHD and Aura h2O	Any idea what is going on here? I reflashed the ereader using the PRS-505 Updater 1.1.00.18040. Then I used the customiser to install and use the Cambria font (which had been modded as per instructions) and to change a couple of other settings (uniform font size and customisation). All went well and the reader was fine - books were readable etc. But when connected by USB (to a windowsxp machine) the reader was detected, calibre found it but the ebook library would not run (said error). Upon disconnecting the usb the reader hung and needed to be reset. Tried the above a couple of times but always the same - everything appeared to be fine until the usb was connected. Tried different fonts - same problem. Next I reflashed and again used the customiser but this time without changing the fonts. Now everything worked as it should. For some obscure reason changing the font is causing a problem ( i believe there was another poster a while back with a similar problem). I am using a UK Reader - could that have anything to do with it? Any suggestions as to what i might try?

Advert

Advert