![]() |
#1 |
Junior Member
![]() Posts: 5
Karma: 10
Join Date: Oct 2015
Device: Kobo Touch
|
![]()
Hello everyone,
My N905C is frozen ![]() I did a basic reset, with no effect. I did a manual factory reset, and as soon as the "power light blinks rapidly" I "Let go of the Home button.". After about a minute, the light stopped blinking, but I do not see the "Restoring" message on the screen. The Kobo is still frozen and does not turn on/off. Using a USB Charge Doctor, it seems as if the Kobo is taking a charge via it's USB port of about 480mAh. I took off the back cover to remove the battery, but I can't figure out how to disconnect the battery from the PCB without braking something ![]() Is there anything else I must try? If the Kobo is totally bricked and I buy a new one, will I still have access to my purchased ebooks? Thank you! |
![]() |
![]() |
![]() |
#2 |
Wizard
![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() Posts: 1,326
Karma: 1077205
Join Date: Jun 2011
Device: Kobo Touch, Sony T1, Kobo Mini
|
White battery connector slides out toward battery wires going to battery. I would use needle nose pliers to grip connector to slide it out. If installing new battery with different connection I would cut battery wires in middle so I could solder new wires to old wires with old battery connector.
|
![]() |
![]() |
![]() |
#3 | ||
Grand Sorcerer
![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() Posts: 24,905
Karma: 47303822
Join Date: Jul 2011
Location: Sydney, Australia
Device: Kobo:Touch,Glo, AuraH2O, GloHD,AuraONE, ClaraHD, Libra H2O; tolinoepos
|
Quote:
Quote:
The last thing to try is to remove the SD card and write a new image to it. I have sent you a PM with the link to the image. But, my recommendation: Use this as an excuse to buy a nice new Glo HD or Aura H2O. Then fix the Touch to use a backup or give away. And, if you are married, practice the line: "Honey, I only found out I could fix it after I bought the replacement". |
||
![]() |
![]() |
![]() |
#4 |
Wizard
![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() Posts: 2,454
Karma: 5469320
Join Date: Jul 2010
Device: Kobo
|
What does the screen look like? What you're describing could be a broken screen substrate as easily as a bricked Kobo.
|
![]() |
![]() |
![]() |
#5 |
Junior Member
![]() Posts: 5
Karma: 10
Join Date: Oct 2015
Device: Kobo Touch
|
@filmo: thanks for the tip on removing the battery, will give it a go
@davidfor: thanks for the PM. I will download the image and give that a go as well @robko: attached, please find a photo of the screen. No matter what I do, it is all that is displayed. ![]() |
![]() |
![]() |
![]() |
#6 |
Junior Member
![]() Posts: 5
Karma: 10
Join Date: Oct 2015
Device: Kobo Touch
|
I downloaded the image and wrote it back to the SD card, did a factory reset, but still nothing. The screen stays exactly the same, and the Kobo is also not picked up by my PC.
![]() I assume it is totally bricked then? |
![]() |
![]() |
![]() |
#7 | |
I need a chapter break
![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() Posts: 4,042
Karma: 56058267
Join Date: Mar 2015
Location: Israel
Device: Kobo Glo
|
Quote:
You write the image on the sd card see here. after you write the image and put it your device, plug it to usb cable to boot it up. Last edited by oren64; 10-15-2015 at 11:22 AM. |
|
![]() |
![]() |
![]() |
#8 |
Junior Member
![]() Posts: 5
Karma: 10
Join Date: Oct 2015
Device: Kobo Touch
|
Sorry for being unclear. Here are the steps I took:
Still, the screen stays exactly the same. |
![]() |
![]() |
![]() |
#9 |
I need a chapter break
![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() Posts: 4,042
Karma: 56058267
Join Date: Mar 2015
Location: Israel
Device: Kobo Glo
|
You write the image correctly.
try charge the battery for couple of hours and try to boot it again. Last edited by oren64; 10-16-2015 at 02:06 AM. |
![]() |
![]() |
![]() |
#10 | |
Grand Sorcerer
![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() Posts: 24,905
Karma: 47303822
Join Date: Jul 2011
Location: Sydney, Australia
Device: Kobo:Touch,Glo, AuraH2O, GloHD,AuraONE, ClaraHD, Libra H2O; tolinoepos
|
Quote:
As you have done a factory reset, force a power off and plug it into a PC. From memory, when you do this with a Touch, the device will start and automatically mount so that the Kobo desktop can access it. If you can see it on the PC at this point, it means the screen is broken. You can do this after the device has started, but that means knowing where to tap on a broken screen. |
|
![]() |
![]() |
![]() |
#11 |
Wizard
![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() Posts: 2,454
Karma: 5469320
Join Date: Jul 2010
Device: Kobo
|
This, and use a different cable/USB port if possible to rule out a charging issue. Screen doesn't look like it has a broken substrate but as David pointed out the "line" across it near the top doesn't look normal either so could be a screen controller issue. But if you aren't getting a charge that will prevent the screen from being changed or a factory reset from working.
|
![]() |
![]() |
![]() |
#12 |
Junior Member
![]() Posts: 5
Karma: 10
Join Date: Oct 2015
Device: Kobo Touch
|
Thank you for the replies.
The battery was fully charged (measured with a DMM) and the device off (pressing the reset button did not trigger boot as seen by the blinking power LED). I connected the device to the PC, and the power LED blinked green, then blue, then green, then blue and then a couple of green flashes. The PC still does not recognize the device, and the display on the device also does not change. While connected to the PC, I monitor the battery with a DMM and the battery is taking a charge ![]() |
![]() |
![]() |
![]() |
#13 |
I need a chapter break
![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() Posts: 4,042
Karma: 56058267
Join Date: Mar 2015
Location: Israel
Device: Kobo Glo
|
If the LED flash and screen is still the same like the picture you post, it may suggest the screen failure/broken.
|
![]() |
![]() |
![]() |
#14 |
Wizard
![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() Posts: 3,489
Karma: 2914715
Join Date: Jun 2012
Device: kobo touch
|
You have to first select the "connect button", only then can the PC recognize the device. If your screen is broken, you can try to poke the "connect" button without seeing it. With FW 3.18.0, the button is in the vertical middle of the screen, around 25 mm from the bottom border.
|
![]() |
![]() |
![]() |
Tags |
frozen, n905c, touch |
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Touch Touch N905C Internal Picture | AskzYDre | Kobo Developer's Corner | 0 | 01-29-2014 02:34 AM |
Touch FW 3.1.1 warning for Mark 4 Touch (N905C) | Darth_Bane | Kobo Developer's Corner | 7 | 01-15-2014 04:12 AM |
Touch Does N905C and N905C differ | lozsui | Kobo Developer's Corner | 2 | 01-06-2014 03:12 AM |
Kobo Touch frozen | Bruinbaard | Kobo Reader | 12 | 08-13-2013 02:13 AM |
Kobo Touch Frozen | tea2 | Kobo Reader | 5 | 09-06-2011 11:30 PM |