Boox Note 3 bricked

[aaron42195]

My Boox Note 3 bricked. Please check the vedio below
https://drive.google.com/file/d/1oKl...ew?usp=sharing
only fastboot mode I can enter.
Any suggesion for me to fix this issue?

[Renate]

You can always fix a Poke3 from software problems.
The worst case is if you lose some calibration data, MACs or serial number if you haven't backed up.

With EDL and the Firehose you can make a full, raw backup that will return your specific device exactly to a certain time point.

You can also use EDL to get to recovery and from there do a "factory reset".

I'm not sure how you use your device, but I've got nothing "precious" on mine.
From a fresh device it would take under 30 minutes to make it like before.

Your video is not public.

[aaron42195]

Originally Posted by Renate

You can always fix a Poke3 from software problems.
...
From a fresh device it would take under 30 minutes to make it like before.

Your video is not public.

Hi Renate,

Thank you for your reply! It has given me some hope.
Could you please suggest any instructions or guides on how to proceed with the steps (such as using EDL mode and the Firehose tool)?
Also, I have now made the video public, so you should be able to view it.

Thanks again for your help!

[Renate]

That's the boot animation.
It runs when the Android subsystem is mostly running but it hasn't started looking for a launcher application yet.

If you had previously enabled ADB you should be able to connect and ask it what it thinks it's doing.
But I guess that you haven't?
With ADB you could just:

adb reboot recovery

Getting into EDL mode is easy if you have ADB:

adb reboot edl

Internal test points always work but can be difficult to access and locate.
EDL test cables should work on most recent Onyx.

[aaron42195]

Is this edl mode?

[aaron42195]

Is this edl mode?[/QUOTE]

[Renate]

Originally Posted by aaron42195

Is this edl mode?

Yes, but I don't like QFIL and virtual com ports (or Python).

[aaron42195]

Originally Posted by Renate

Yes, but I don't like QFIL and virtual com ports (or Python).

I can use edl.exe.
What is my next step?
Sorry, I don’t know much about this part.

[aaron42195]

Originally Posted by Renate

Yes, but I don't like QFIL and virtual com ports (or Python).

I use edl/l command. Get the result below.

C:\Temp>edl /l
Found EDL 9008, handshaking... version 2.1
HWID: 000cc0e100000000, JTAG: 000cc0e1, OEM: 0000, Model: 0000
Hash: 7be49b72f9e43372-23ccb84d6eccca4e-61ce16e3602ac200-8cb18b75babe6d09 (x3)